Routing – Page 3 – routingloop.net

It works! (kinda)

We finally have spoke to spoke traffic working in our phase 1 DMVPN! After fixing the BGP third party next hop issue described in the last post we still had reachability issues between spokes. The spokes could reach the hub and the hub could reach the spokes just fine. Traffic transiting the hub to route

Home Lab DMVPN Lessons Learned

19MarchStevenHome Lab, Routing

My last post was about the home-to-home DMVPN we’ve been working on. The design intent was to build a phase 1 DMVPN so spoke to spoke traffic should use the hub as a transit node. It wasn’t until we tried to forward traffic from spoke to spoke that we realized we have issues. Spoke to

Home to Home DMVPN and Raspberry Pi Wireless Links

17MarchStevenHome Lab, Routing

Some months ago, I got in contact with one of my old colleagues and friend. Our discussion led to trying to decide what to do next with our home labs. He mentioned that he has a small block of provider assigned public IPv4 addresses. We got what seemed like a crazy idea – “Let’s do

eBGP, TTL and Connected-Check

4MarchStevenHome Lab, Routing

It is well known that eBGP packets default to having a Time to Live (TTL) value of 1. This has caused confusion for many network practitioners who wish to run eBGP between loopback addresses of directly connected routers. This misunderstanding sometimes leads to ebgp-multihop being configured when it is not necessary. This also gave me

Next Hop Recursive-Looped

4FebruaryStevenHome Lab, Routing

In this morning’s lab exercise I intentionally designed and configured a network to cause recursively looped routing lookups. When I started the experiment, I did not know this is the term for this condition. I simply wanted to see what would happen if the route to the destination was also the route to the next

OSPF Autoconfiguration with Python

28JanuaryStevenHome Lab, Python, Routing

I find that sometimes when I want to lab up a specific scenario I have to do the same “router ospf 1234” and “network 198.51.blah.blah area blah” commands over and over just to get basic routing configured. Awhile ago I wrote an EIGRP auto configuration script but at that time I didn’t know about the

Soft Reconfiguration Inbound

28JanuaryStevenHome Lab, Routing

This morning I set up an eBGP session between routers with a switch in the middle configured for SPAN. The SPAN session sent the output to my laptop for Wireshark analysis. Of course, I would need prefixes in BGP to have something to observe. I took inspiration from Free Range Routing’s sharpd feature and wrote

routingloop.net

A place for me to ramble about computer networking.

Category Archives: Routing