Steven – Page 4 – routingloop.net

STP Bridge Priority 4096

Have you ever wondered why per-VLAN spanning tree only accepts bridge priority values in increments of 4096? I have. I spun up a lab and Wireshark to figure it out. In Cisco IOS, if you attempt to configure a bridge priority value that is not an increment of 4096 the CLI will print a helpful

Multicast Calculator

18JanuaryStevenPython

Last week I was diving into IP multicast and decided to write a multicast calculator in Python to reinforce multicast addressing schemes. When the script is ran, it prompts the user for an IP address. If an IPv4 or IPv6 multicast address is entered, the corresponding multicast MAC address is calculated and returned. If an

PIM RP Redundancy that (kinda) Works

10JanuarySteven1 CommentHome Lab, Routing

I spent a few minutes thinking about anycast RP for PIM sparse-mode deployment and thought of a way to provide RP redundancy without auto-RP or BSR to dynamically learn RPs, and without using MSDP to synchronize active source information between anycast RPs. There is a major pitfall to this approach but it can work. Demo

ToS Byte Reference Sheet

10JanuaryStevenENSLD

This morning I put together a spreadsheet all about the Type of Service byte and it’s associated DSCP and ECN markings. Feel free to download it and reference or modify it as you see fit.

STP Priority

31DecemberStevenHome Lab, Switching

When learning protocols, I like to build out a lab, take packet captures, debugs, and show commands and try to understand and justify the output. My most recent exercise is with PVST+. I built out the 6-switch topology below in CML. One of the first things I experimented with is bridge priority configuration. VLAN 10

AS Boundary Links in IGP?

14DecemberStevenENSLD, Home Lab, Routing

Lately I’ve been focusing on honing my BGP skills to prepare for the ENSLD exam. While this isn’t a configuration focused exam, I’ve been spending some lab time on it to reinforce design concepts. I built out a 29-node lab in Cisco modeling labs featuring eBGP, iBGP, route reflectors, BGP confederations, and eBGP third party

Information Hiding in Routing Systems

19NovemberStevenHome Lab, Routing

One of the most effective methods to build stable and scalable routing designs is to summarize topology and reachability information in routing protocols. Summarization can help networks converge faster and limit the number of routers that need to perform route calculations when an event such as a link flap occurs. However, there are tradeoffs to

Static Routes, Exit Interfaces, Ethernets

9SeptemberStevenHome Lab, Routing

Ethernet Ethernet allows multiple hosts to share the same network segment. There are only 3 ways to deliver a frame to another computer over ethernet. You can send a broadcast and interrupt every host on the segment, send a multicast and hope that the intended receiver is listening, or send a unicast by placing the

Faster EIGRP Feasible Successor Failover

10AugustStevenHome Lab, Routing

The feasible successor is EIGRP predetermining an alternate next hop to reach a destination for fast failover. The feasible successor route is stored in the EIGRP topology table but is not installed in the RIB/FIB by default. The variance command can be used to promote the feasible successor to the routing table and traffic will

OSPF in Phase 1 DMVPN Networks

21JuneStevenENSLD, Home Lab, Routing

When designing hub and spoke networks, most architects will opt for distance or path vector routing protocols when given the choice. I don’t blame them, distance/path vector provides several benefits that work well in hub and spoke topologies. EIGRP based hub and spoke networks can scale to thousands of spokes without much work. Route summarization

routingloop.net

A place for me to ramble about computer networking.

Author Archives: Steven